Cooling and humidification
Adiabatic Mist Cooling Systems
When ambient temperature climbs, air-cooled condensers and chillers lose capacity just when you need it most. Adiabatic mist pre-cooling lowers the air temperature entering the coil and gives that capacity back.
How adiabatic pre-cooling works
High-pressure nozzles create a fine mist in the air stream ahead of the condenser coil. As the mist evaporates it absorbs heat, so the air reaching the coil is cooler than ambient. Lower condensing temperature means lower head pressure, less compressor power and more cooling capacity.
The system is controlled by ambient temperature and humidity, and runs only during the hours when it delivers a benefit.
Where it is used
- Air-cooled chillers and rooftop units
- Process and refrigeration condensers
- Dry coolers and fin-fan coolers
- Gas turbine and compressor inlet air
- Transformer and generator yards
- Data centre and district cooling plant
Designed to protect your equipment
Poorly designed misting can scale or corrode coils. Ours is engineered to avoid that.
- Water treatment and filtration matched to your supply
- Droplet size and nozzle position selected for full evaporation before the coil
- Staged control so mist output follows the weather
- Automatic drain and flush cycles
- Stainless steel lines and anti-drip nozzles
Related cooling solutions
Frequently asked questions
Does mist cooling work in Gulf humidity?
Evaporative cooling performs best in hot, dry air, which is typical inland and for much of the day. In coastal, humid conditions the temperature drop is smaller, so we design with the local climate data and often combine mist with air movement to maintain comfort.
What water quality is required?
High-pressure nozzles have very small orifices, so filtered, low-hardness water is important. We include filtration and, where needed, water softening or RO in the system to protect the nozzles.
How often do the nozzles need maintenance?
With correct filtration, nozzles typically need only periodic inspection and cleaning. Anti-drip nozzles are removable by hand and inexpensive to replace.
Planning a cooling or humidification project?
Send us the area, ceiling height and the temperature or humidity you need to reach. We will size the pump, lines and nozzles for you.